The American Architectural Manufacturers Association (AAMA) has published a compilation of standards, specifications and test methods for determining the performance of compounds, sealants and tapes used in the manufacture and installation of windows, sliding glass doors and curtainwalls.

Originally released in 1986, AAMA 800, Voluntary Specifications and Test Methods for Sealants, has been revised and updated. The 2010 version of the document includes the following product specifications:

• Back bedding compounds;

• Back bedding mastic glazing tapes;

• Back bedding hot applied sealants;

• Narrow joint seam sealers;

• Exterior perimeter sealing compounds;

• Non-drying sealants; and

• Expanded cellular glazing tapes.

Sub-sections of AAMA 800-10 cover different classifications of back-bedding compounds and hot applied sealants, such as Type I and Type II compounds, both of which are intended to remain ductile and permit moderate movement without loss of bond. Type I is recommended for intermittent water contact, while Type II is recommended for extended water contact, but not continuous immersion. Group A and Group C back bedding compounds that are additionally intended to bond or adhere the glass to the substrate are covered in a new section. Both compounds cure relatively hard and stiff yet also permit limited movement. Group A sealants demonstrate peel adhesive failure, while Group C demonstrates predominately cohesive failure.

Other subsections define classifications of back bedding mastic type glazing tapes, which are 804.3 for tapes used in less severe back bedding and drop-in glazing applications such as residential and light commercial fenestrations, 806.3 for those used in high-performance commercial fenestrations in which the tape is subjected to continuous pressure exerted from gaskets, and 807.3 for tapes used in commercial fenestrations in which the tape is not subjected to continuous pressure.

Performance requirements specified as applicable to the type of sealant or tape include visual screening, hardness, thin film integrity, peel and/or tensile adhesion, yield strength, compression/deflection and/or compression set, lap shear strength with exposure, slump, sag, vehicle migration, low temperature flexibility, staining (will not stain the substrate beyond the applied bond line) and water resistance.

Section 2 of AAMA 800-10 provides details on the various test methods indicated for determining compliance with these performance requirements and includes elaborations for each test concerning, as applicable, the materials required, specimen and/or substrate preparation, specimen conditioning and/or cure and exposure, procedural details, calculations and/or evaluation, and results reporting. The section is liberally illustrated with photos and diagrams of the test procedures and the foundational ASTM methods are referenced.

The final section, Laboratory Test Method Notes, offers tips for sealant sampling, optional cure/pre-cure/pre-conditioning methods, substrate preparation, dealing with gunnable sealants with spacer beads and mastic type tapes with spacer shims, test methods to determine compatibility with laminated glass and plastic glazing beads or setting blocks and test equipment alternatives and sources.

Visit the AAMA Online Publication Store for more information or to purchase.


Leave a Reply

Your email address will not be published. Required fields are marked *